The movement trajectory planning is controlled inside servo. The cnc controller only needs to transfer the signals of the target position, speed, and acceleration information to servo diver. So the drive can predict the next moment of motion parameters, and then forward measures to improve the performance of motion control.
Control system wiring connection easily
The control system of the pulse type driver is required to be connected with each driver through the pulse cable, which often causes the control system and the drive cable to be dense and complex. But WISE M II driver only needs to use one cable connection with one of the drives, and the rest drives can be connected with the driver by using the chain type method.
Control unit interface requirements reduced, lower cost
Multiple bus drivers only need one interface to connect with motion control system. The control system does not require the pulse modules, and also do not need to consider increasing the number of control systems to adapt to multiple drives. In this way, it can save more pulse modules and the cost of multiple control systems.
WEIHONG WISE servo with Mechatrolink-II bus protocol can provide higher precision machining effects applied in cnc woodworking, 3C, waterjet, metal mold industry, etc.
